Trailer Wheel Bearing Kits: Whats Included, Why You Need One, and How to Install for Peak Performance
Whats Included in a Trailer Wheel Bearing Kit?
A trailer wheel bearing kit typically includes all the components necessary to service one trailer wheel bearing. These components usually include:
- Bearings (inner and outer)
- Seals
- Grease
- Cotter pins or retaining rings
- Dust caps
- Washers
Having all these parts in one kit ensures you have everything needed to complete the job without having to source individual components.
Why You Need a Trailer Wheel Bearing Kit
Trailer wheel bearings are critical for the smooth operation and safety of your trailer. Over time, bearings can wear out, become damaged, or lose their lubrication, leading to increased friction and heat. This can cause the bearings to fail, which may result in a wheel locking up or even detaching from the trailer. Regularly replacing your trailer wheel bearings with a high-quality kit can:
- Prevent catastrophic failures
- Ensure smooth and safe towing
- Extend the life of your trailer
- Save money on repairs in the long run
Reach Out To Us Today!:
Ready to upgrade your trailer\’s performance? Visit Canadian Axle Inc. at 3790 Davidson Rd, Inverary, ON K0H 0A9, Canada, or call us at +1 613-653-7839 to get your trailer wheel bearing kit today!
How to Install a Trailer Wheel Bearing Kit for Peak Performance
Installing a trailer wheel bearing kit is a straightforward process, but it requires attention to detail to ensure peak performance. Heres a step-by-step guide:
- Preparation: Gather all tools and components from the kit. Ensure you have a clean workspace.
- Remove the Old Bearings: Jack up the trailer and remove the wheel. Take off the dust cap, cotter pin, and castle nut. Push the hub out to access the bearings.
- Clean the Hub: Thoroughly clean the hub to remove any old grease and debris.
- Install New Bearings: Pack the new bearings with the provided grease. Install the inner bearing and seal into the hub. Slide the hub back onto the spindle, and install the outer bearing, washer, and castle nut.
- Adjust and Secure: Tighten the castle nut until its snug, then back it off slightly to allow for proper bearing preload. Insert the cotter pin and secure it. Install the dust cap.
- Final Check: Spin the wheel to ensure it rotates smoothly without excessive play. Reinstall the wheel and lower the trailer.
By following these steps, you can ensure your trailers wheel bearings are installed correctly for optimal performance and longevity.
Reach Out To Us Today!:
Don\’t compromise on safety and performance. Get your trailer wheel bearing kit from Canadian Axle Inc. located at 3790 Davidson Rd, Inverary, ON K0H 0A9, Canada. Call us at +1 613-653-7839 to place your order now!